Home > Electronics >

Spedix IS35 35A 20x20 4-in-1 BLHeli_S ESC
Spedix IS35 35A 20x20 4-in-1 BLHeli_S ESC


 
Alternative Views:


Our Price: $51.99 CAD

Stock Status: In Stock
Product Code: ESC-SPX71074
Qty:

Description
 
Spedix IS35 35A 20x20 4-in-1 BLHeli_S ESC

The board supports a continuous current of 35 amps, with burst support up to 45 amps for 10 seconds. The 8-pin socket allows for
clean and simple builds when combined with a flight controller that has a compatible connector (pin-outs may need to be swapped!).

***Now with multiple custom pinouts!



FEATURES
  • High reliability.
  • This design allows low profile stack and prevent interference's between wires, ESC, and flight controller.
    • The highest part on the PCB is only 1.6mm tall
  • The potential interference between standoffs and electronic parts were also taken into consideration in the design. Fragile parts are now away from the mounting holes.
  • The silicone rings provided will prevent the standoffs to short the PCB and electronics parts during a crash.
  • The small size and square shape of the ESC board is compatible with most frames available in the market.
  • The product comes with 2 different cables and spare connector housings to accommodate the multipin connectors used on different flight controllers.


SPECIFICATIONS
  • Input Voltage: 2-5S
  • Max. Continuous Current: 35A
  • Max Burst Current: 45A (10 sec.)
  • Firmware: Blheli_S
  • BEC: No
  • Current Detection: Yes
  • Dimensions:29x32x6.5mm
  • Stack Size: 20x20mm, M3 mounting holes
  • Weight: 7g



PACKAGE CONTENTS
  • 1 x 35amp 4in1 ESC
  • 1 x 10cm red & black 16AWG wire pre-soldered
  • 1 x Wiring and customizable pinout kit
  • 1 x 25v 330μF Rubycon capacitor
  • 1 x Datasheet



Notice
  • If 5S is used, it's HIGHLY recommended to solder the included capacitor.
  • The amperage meter scale needs to be set to 200 for the current sensor to work.

Share your knowledge of this product. Be the first to write a review »