Home > Electronics >

HelioRC SPRING AIO IMU-F Flight Controller
HelioRC SPRING AIO IMU-F Flight Controller

Alternative Views:

Our Price: $60.99 CAD

Stock Status:(Out of Stock)

HelioRC SPRING AIO IMU-F Flight Controller

Power: VBAT up to 6s with voltage regulator 2.5A continuous 3.2A burst

  • A gyroscope that is filtered using advanced statistical methods to smooth noise trends. Instead of sending gyro measurements to the F4 it sends quaternion (a fancy math term it tells the flight code the orientation).

Truly Freeing
  • Supported by multiple open source flight controller software including ButterFlight's & Betaflight’s 3.3+ most current technologies.

Natively Fast
  • True 32khz processing without overclocking
  • Highly advanced filtering at 32khz and quaternion output at 16khz. Even $2500 gyros aren’t capable of that.

  • Never before seen IMU-F system an advanced inline discrete filtered gyro that is transparent to the flight controller.
  • With a super clean discrete filtered gyro, more processing power is available for flight controller logic and future feature updates without causing slowdown or issues during flight.

Helio Gyro
  • The hardware contains both an F3 (IMU-F) and an F4. The gyro is the 20601.

  • The added power to the board is solely dedicated to filtering junk data into a pure jet stream of clean flight data. (Gyro noise is a huge problem for stable flight.)

  • Our IMU-F is specifically built to break, tackle, and crack noise trends to provide an unparalleled flight experience.

  • PDB: 6S 200A capable
  • Processors: F4 & F3, STM32F405 & STM32F301
  • IMU: ICM 20601
  • OSD: Full ButterFlight OSD support with LC FILTER
  • Motor Outputs: Full DSHOT and MULTISHOT support.
  • Receiver Support: PPM, S.Bus (inverter built-in), DSM, HoTT, SRXL, CSRF, FPort ready. 5V or 3.3V supply for receiver.
  • Telemetry Support: FrSKY Smart Port, FrSKY Sensor Hub, HoTT Telemetry, SRXL, CSRF, FPort ready. Built-in inverter for FrSKY telemetry.
  • Serial Ports: 5 full serial ports (UARTs). UART1 and UART2 have inverters for S.Bus and SmartPort telemetry.
  • Buzzer Port: Dedicated port for 5V (100mA max) buzzers.
  • Analog Inputs: Voltage sensing up to 26V, current and RSSI inputs (3.3V max).
  • Power: VBAT up to 6s with voltage regulator 2.5A continuous 3.2A burst

Share your knowledge of this product. Be the first to write a review »