Home > Electronics >

Heli-Nation Talon F7 Fusion 20x20 Flight Controller
Heli-Nation Talon F7 Fusion 20x20 Flight Controller


 
Alternative Views:


Our Price: $47.99 CAD

Stock Status: In Stock
Product Code: ELEC-TALONV2-F7-FUSION-FC
Qty:

Description
 
Heli-Nation Talon F7 Fusion 20x20 Flight Controller

The Talon F7 Fusion is almost identical to the Talon F7 but with one key difference. The Fusion utilizes a dual gyro system set up in 90° phase to each other. These two ICM20602 gyros work in tandem to produce ultra-filtered data to your FC to give you the most locked-in flying experience yet!



To get Motor 4 to work please use the CLI command below using Betaflight V4.0.4. A custom hex is coming soon for 3.5.7 and 4.0.4.
Resource MOTOR 6 None
Resource MOTOR 4 C08
Save

To get 5V to your VTX please go to the mode tab in Betaflight and setup a mode switch for vtx_pit





SPECIFICATIONS
  • MCU: STM32F722RET6 216MHz
  • 2x ICM20602 GYROS 90 deg phase
  • Built-in Betaflight OSD
  • Up to 8S (36V) direct battery power
  • Buzzer pads for external buzzer
  • Built-in voltage monitoring resistor
  • 5V 2A BEC
  • Dedicated LDO for Gyro, noise-free gyro power
  • Dedicated LDO for OSD, cleaner OSD signal
  • Led strip shares 5V with 5V/2A BEC
  • 6 UARTS: UART1, UART2, UART3, UART4, UART5, UART6
  • Built-in camera control pin with resistor and capacitor
  • 5 Full UARTS with RX AND TX pins
  • Logical pin layout for cleanest build possible
  • 8 pin 4 IN 1 ESC plug
  • Remappable LED pad for additional motor output
  • TX3, RX3 can be used for I2C for external compass
  • 5V, VBAT selectable VTX and CAM power
  • 16M Blackbox flash chip
  • No flicker VTX pit mode switch (positive switch)
  • M4 Can be selected either led_strip signal or M4 signal for RPM filtering
  • 20 X 20 mounting hole with true 25mm board dimensions



PACKAGE CONTENTS
  • 1 x Flight Controller
  • 1 x Hardware Kit
  • 1 x 8pin Harness
  • 1 x XT30 Connector

Share your knowledge of this product. Be the first to write a review »